Where Is The Wps Button On Verizon Router G3100 (2024)

FAQs

Is there a WPS button on a Verizon FiOS router? ›

The front panel's unified button allows quick access to the Wi-Fi Protected Setup (WPS) feature and pairing mode. The Router Status LED will be solid white when your Fios Router is turned on, connected to the internet, and functioning normally. The WPS button is used to initiate Wi-Fi Protected Setup.

Alternatively, enter 192.168.1.1 into the URL address field. From the log-in screen, enter the Network Settings password printed on the label on the rear of your router. The first time you access your Verizon Router, an Easy Setup Wizard displays to guide you through the setup process.

Push the WPS button on the router.

The button will typically begin to flash amber/orange, letting you know it is searching for a device to connect. 2. In the device's WiFi settings, locate and select the name of the wireless network (SSID) you're trying to connect to.

If your router doesn't have a physical WPS button, you can still enable WPS functionality through the router's web interface. Access the router's settings by typing the router's IP address into a web browser. Look for the WPS settings and follow the instructions to activate it.

To connect to a WPS-enabled router, press the WPS button on your router or access point. Press and hold down the Wi-Fi button on your product for 3 seconds. Note: Be sure to press and hold the Wi-Fi button on your product within 2 minutes of pressing the WPS button on your router or access point.

Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access point. If there is no hardware button, there may be a virtual WPS button in the software for the device.

To activate the WPS function, press and hold the WPS button located on the rear of your Verizon Router for more than two seconds.

When all else fails, try unplugging the router and modem for about 60 seconds, to reset them, then plug them back in. This will reset them with the ISP and may fix the problem. If that didn't do it, the next step to try is manually removing and re-adding the Wi-Fi network from the device's settings.

What does a blue blinking light mean on a Verizon router? ›

Usually, the blinking blue light on the Verizon router means it is in pairing mode and trying to connect to a WPS device. This happens when you press the WPS button, and the router should go back to normal solid blue (or white) light after a couple of minutes.

The WPS button is used to initiate Wi-Fi Protected Setup. This is an easy way to add WPS capable devices to your Wi-Fi network. To activate the WPS function, press and hold the WPS button located on the rear of your Verizon Router for more than two seconds.

Holding the reset button for 10 seconds will reset the device to factory default settings. The LED light turns off along with the device.

A reset to factory default deletes all changes made to the configuration and connected clients need to reconnect. It's advisable to perform a backup before performing a factory reset.

Press the WPS button on your gateway within two minutes. See where the WPS button is located on different gateways in the pictures below. The computer or WiFi product will display a success message when it's connected to your home network.

A green light means you are connected to the ISP. A blinking green indicates there is traffic being passed; if it's not blinking you have a connection but no traffic is being passed.

(top-right edge) to turn on the display. Tap 'Primary Network WPS' or 'Guest Network'. Tap one of the WPS connection options: Use WPS button.